Ultra Wide Band Extension
Introduction
The following figure shows the architecture details during the development phase:
On the nRF52832 the firmware is developed using the C API based on the PANS stack released by Decawave. The communication with the Elisa-3 robot is accomplished through I2C (the robot is the slave). The nRF52 is programmed/debugged through the SWD interface using an external nRF dev kit attached to the computer via USB. An additional UART is attached to the UWB module in order to get logging info.
Source code
Based on dwm-simple example from the package...
Embedded Segger (as explained in)