Difference between revisions of "e-puck2 programmer development"

From GCtronic wiki
Jump to: navigation, search
(Get the source code)
 
Line 4: Line 4:
 
The programmer firmware source code can be downloaded with the command:<br/>
 
The programmer firmware source code can be downloaded with the command:<br/>
 
<code>git clone --recursive -b e-puck-2.0_E https://github.com/e-puck2/e-puck2-programmer</code><br/>
 
<code>git clone --recursive -b e-puck-2.0_E https://github.com/e-puck2/e-puck2-programmer</code><br/>
 +
 +
==Building==
 +
In order to build the firmware you need to issue the following commands from the <code>src</code> directory of the repo root:<br/>
 +
<code>make clean</code><br/>
 +
<code>make PROBE_HOST=e-puck/2.0</code><br/>
 +
The result is a bin file named <code>e-puck2_programmer.bin</code> that you can find in the <code>src/platforms/e-puck/2.0/build</code> directory.<br/>
  
 
=Configuring the Programmer's settings=
 
=Configuring the Programmer's settings=

Latest revision as of 08:20, 1 April 2019

e-puck2 main wiki

Get the source code

The programmer firmware source code can be downloaded with the command:
git clone --recursive -b e-puck-2.0_E https://github.com/e-puck2/e-puck2-programmer

Building

In order to build the firmware you need to issue the following commands from the src directory of the repo root:
make clean
make PROBE_HOST=e-puck/2.0
The result is a bin file named e-puck2_programmer.bin that you can find in the src/platforms/e-puck/2.0/build directory.

Configuring the Programmer's settings

The on-board programmer of the e-puck2 is based on the Blackmagic probe open source project firmware.
Some functionalities has been added on top of the original project to be able to control some functions of the robot, for example the power on or power off.

To access to the available commands of the programmer, it is needed to connect to the programmer with a GDB console.
To do so, you have to type the following command in a terminal window with the com port used by the 'e-puck2 GDB Server port of your e-puck2 :

arm-none-eabi-gdb 
target extended-remote your_gdb_com_port

Once connected to the programmer with GDB, you can type

monitor help
or
mon help
to print the available commands of the programmer.

One command in particular is useful, which is mon select_mode. It is used to select in which mode the e-puck2 Serial Monitor com port will work.
mode 1 = the serial monitor is connected to the UART port of the main processor
mode 2 = the serial monitor is connected to the UART of the ESP32
mode 3 = the serial monitor works as a Aseba CAN to USB translator

The choice made for the mode is the only setting that is stored in a flash zone of the programmer, which means the choice is remembered, even if the robot is completely turned off.

Note : in mode 1 and 3, GDB can be used over the bluetooth connection of the e-puck2. But is is much slower than with USB and it doesn't work with Windows due to GDB limitations on this OS.

By being connected with GDB, you can also use the standard GDB command to program and debug the main processor of the e-puck2.