e-puck2 programmer development: Revision history

17 June 2020

• curprev 05:5805:58, 17 June 2020‎ WikiSysop talk contribs‎ 2,370 bytes +19‎ →‎Get the source code
• curprev 05:5605:56, 17 June 2020‎ WikiSysop talk contribs‎ 2,351 bytes −16‎ →‎Get the source code

18 December 2019

• curprev 12:3812:38, 18 December 2019‎ WikiSysop talk contribs‎ 2,367 bytes +13‎ →‎Configuring the Programmer's settings

18 October 2019

• curprev 07:0807:08, 18 October 2019‎ WikiSysop talk contribs‎ 2,354 bytes 0‎ →‎Configuring the Programmer's settings

1 April 2019

• curprev 08:2008:20, 1 April 2019‎ WikiSysop talk contribs‎ 2,354 bytes +371‎ No edit summary

17 December 2018

• curprev 13:3513:35, 17 December 2018‎ WikiSysop talk contribs‎ 1,983 bytes +179‎ →‎Get the source code
• curprev 13:3413:34, 17 December 2018‎ WikiSysop talk contribs‎ 1,804 bytes +21‎ No edit summary

3 August 2018

• curprev 05:0505:05, 3 August 2018‎ WikiSysop talk contribs‎ 1,783 bytes +46‎ No edit summary

31 July 2018

• curprev 05:1305:13, 31 July 2018‎ WikiSysop talk contribs‎ 1,737 bytes −934‎ →‎Using the DFU
• curprev 04:2404:24, 31 July 2018‎ WikiSysop talk contribs‎ 2,671 bytes −595‎ →‎Using the DFU

27 July 2018

• curprev 13:3113:31, 27 July 2018‎ WikiSysop talk contribs‎ 3,266 bytes −2,220‎ →‎Flashing the programmer
• curprev 11:5611:56, 27 July 2018‎ WikiSysop talk contribs‎ 5,486 bytes +3,268‎ No edit summary
• curprev 11:5511:55, 27 July 2018‎ WikiSysop talk contribs‎ 2,218 bytes +2,218‎ Created page with "===Flashing the programmer=== First of all to update the programmer's firmware you need to enter DFU mode (device firmware upgrade). To do it refer to section [http://www.gctr..."